bonding drywall to wood, studding, rafters, galvanized steel, ceiling systems, aluminum, drywall, other surfaces and foamboard.
NOT Recommended For:
exterior wall construction.
Using a 1/4" (.64 cm) bead: 28 fl. oz. cartridge covers 88 lineal ft.
*Please note that the typical dry time for most construction adhesives is approximately 24 hours. This may vary due to temperature, humidity amount of product applied and surface porosity.
You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.
Surfaces must be clean, dry and structurally sound.
Cut and pre-fit materials prior to installation. Cut wall adhesive nozzle to desired bead size marked on nozzle. Puncture inner seal with nail or wire. IMPORTANT: For best results, set drywall onto wall adhesive within 15 minutes of application.
Apply a 1/4" bead of wall adhesive directly onto studs and plates. Press drywall firmly against wall adhesive and adjust as necessary. Holding drywall's outer edges, nail every 16" and, as necessary, inside the field. Note: If studding is perfectly true, nailing inside field will not be required.
Apply 1/4" bead of wall adhesive to rafters. Fasten drywall's outer edges with nails, 12" on center. Fasten center of field with a nail at each rafter. Drywall larger than 4' x 8' should be fastened with 2 nails in the field of each rafter.
Apply a 1/4" bead of wall adhesive to structure. Some uses: bonding drywall to drywall and drywall to expanded insulation panels.
Use water to clean up wet construction adhesive.
Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.
Price and item availability may vary.