Fiberglass Reinforced Plastic Panel Adhesive (FRP-300)

Key Features

• Excellent gap filling
• Trowel grade adhesive
• Guaranteed not to burn through panels

Recommended For:

adhering FRP panels to cured concrete, cement backerboard, drywall, wood and greenboard.

NOT Recommended For:

adhering FRP panels to wallpaper, exterior surfaces and foamboard (polystyrene). Not recommended for adhering NRP Panels, such as Plas-Tex® from Parkland Plastics.

Available Sizes

• 1 Gallon (3.785 l) can

Coverage

• On smooth surfaces: 1 Gallon (3.785 l) can covers 50 sq. ft.

Specifications

ASTM C-557

• Download MSDS Sheets
• Download Technical Data Sheets

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

 

Surface Preparation

For best results, adhesive and substrates should be between 50° and 90°F. Surfaces must be structurally sound and dry, free of grease, dirt, dust, wallpaper, paint or anything that would interfere with a bond. Level any high spots, and fill all cracks and holes with appropriate fillers.

Application Prep

1. Cut and pre-fit FRP panels. 2. Spread adhesive with the recommended trowel over the entire back of the FRP panel. 3. As soon as adhesive is spread over entire panel and before adhesive skins over (within 45 minutes), set panel in position and press against wall. 4. Press panel firmly into place, working from the center to the edges until full contact has been made. 5. Bracing may be required if walls or panels are not completely straight. 6. For channel moldings, permanent fasteners and panel spacings, follow FRP panel manufacturer's specifications. For application over concrete: Concrete surfaces need to be dry and completely cured. When installing FRP panels over below-grade concrete where moisture can penetrate, you must first attach furring strips to the concrete block and then attach a solid surface, such as wood or drywall, to these furring strips, then continue with standard FRP application.

Drying Time

Working time: Up to thirty minutes. Very warm, dry conditions will decrease working time.

Cleanup

Use mineral spirits to clean up wet or dry adhesive. Note warnings on mineral spirits container.