Paneling & Molding Adhesive (low-VOC) (LN-710)

Key Features

• Retains precise placement
• Reduces nailing
• Impact resistant
• Contributes to LEED^® certification
• Contributes toward NAHB National Green Building Standard™ certification of the structure

Recommended For:

corkboard, paneling, wood molding, foil and insulation board.

NOT Recommended For:

uses other than paneling and molding installations, use between two non-porous surfaces, exterior use.

Available Sizes

• 10 fl. oz. (296 ml) cartridge

Coverage

• Using a 1/4" (.64 cm) bead: 10 fl. oz. (296 ml) cartridge covers 30 lineal ft.

Max VOC

69 GPL

• Download MSDS Sheets
• Download Technical Data Sheets

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

 

Surface Preparation

All panels must be separated and conditioned to room temperature for 48 hours prior to installation. Preparation: Surfaces must be clean, dry and structurally sound. Cut and pre-fit materials prior to installation.

Product Application

1. Cut nozzle at a 45° angle to desired size. 2. Puncture inner seal with nail or wire. 3. Adhere materials within 20 minutes of gunning adhesive. Due to panel inconsistencies, for best results, bracing and/or nailing may be required. Instant grab method for paneling: Apply 1/4" bead of adhesive approximately 1" from edge of panel around the perimeter. Apply two zig-zag 1/4" beads in the middle of the panel. Press panel firmly into place. Remove panel from wall for one minute. Rejoin panel to wall. Molding: Apply 1/4" zig-zag bead to back of molding. Press molding firmly into place. Starting at one end, nail every 12".

Cleanup

Water cleanup while wet. Mineral spirits when dry.