bonding and repairing brick, concrete, stone and timber, including use as a wall adhesive for retaining walls and landscape applications such as garden walls, planters, walkways, steps and capstones.
NOT Recommended For:
NOT for use in water immersion applications. Note: When creating structures higher than 3 feet in height, consult block manufacturer for specific construction instructions.
Using a 3/8" (10mm) bead: 10 fl. oz. cartridge covers 14 lineal ft.
APA AFG-01, ASTM C 557
You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.
Surfaces should be clean and dry at time of adhesive application.
Insert wall adhesive cartridge into caulk gun. Cut the tip on the nozzle at a 45° angle for a desired bead size of 1/4" or 1/2". Puncture seal inside the nozzle where the nozzle meets the cartridge with a long nail or wire. Apply the wall adhesive to the underlying block that the next course or cap stones will be glued onto. The wall adhesive should be applied in a bead 1/2" from edge along the front and along the back of the block. Install the cap stones or block within ten minutes after the wall adhesive has been applied.
Do not allow traffic on stairs or use of walls for 16 hours after application of wall adhesive. Do not apply to wet surfaces.
Working time 15 minutes. Fully cured in 1 week.
If the wall adhesive is wet, use water. If the wall adhesive has dried, scrape it away, then remove residue using a cloth dampened with mineral spirits.
Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.
Price and item availability may vary.