increasing the structural integrity of walls and subfloor systems using plywood, waferboard, lumber and treated lumber, particleboard and foamboard.
NOT Recommended For:
bonding underlayment directly to concrete or for uses other than subfloor, deck and wall system installation.
28 fl. oz. cartridge
10 fl. oz. cartridge
28 fl. oz. cartridge covers 88 lineal ft.
Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 30 lineal ft.
APA-AFG-01, ASTM D-3498 and C-557
*Please note that the typical dry time for most construction adhesives is approximately 24 hours. This may vary due to temperature, humidity amount of product applied and surface porosity.
You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.
Make sure that all surfaces are clean, structurally sound and free of excess water. Wood may be damp, but the adhesive will take longer to dry. LN-902 can be applied at temperatures as low as 22° F (-6 degrees C).
Condition LN-902 to at least 40° F (4° C) for easier gunning. Adhere materials within 15 to 20 minutes of gunning adhesive. Make sure skin of bead is broken. If it's not, scrape off and apply fresh bead. Allow 24 hours drying time before using construction area.
Foam Insulation, Foamboard, Paneling, Corkboard, etc. to Flat Surfaces
Apply a 1/4" (.64 cm) bead near the outside edges throughout field in lines 12" apart.
Subflooring (Conventional Tongue And Groove)
For added strength and to prevent squeaking, lay one 1/4" (.64 cm) zig-zag adhesive bead on each joist. On supporting joists where sheets meet, lay two zig-zag 1/4" beads for added strength and to prevent squeaking. Lay sheets with plywood face grain at right angle to joists. Space joists the thickness of a putty knife to allow for wood expansion. Nail section into place with 8d annular or spiral nails 12" (30 cm) on center on all joists. Subfloor must be under roof within 6 weeks of construction. For additional information regarding subfloors, refer to the American Plywood Association (APA) bulletin, "APA Glued Floor System."
Follow manufacturer's instructions.
Dries in 24 hours. Full cure in two weeks.
Excess fresh adhesive can be removed with water. Dried adhesive can be cleaned with mineral spirits.
Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.
Price and item availability may vary.