- Retains precise placement
- Reduces nailing
- Impact resistant
- Instant grab for easier installation
installing crown molding, paneling, molding and trim and furring strips.
NOT Recommended For:
outdoor use or uses other than paneling and molding installations. Not recommended for plastic molding or trim or 1/8" thick medium-density fiberboard (MDF) paneling.
- Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 32 lineal ft.
You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.
Make sure that all surfaces are clean, dry and structurally sound before this fast-bonding adhesive is applied.
Cut and pre-fit materials prior to installation. Insert tube of fast-bonding adhesive into standard caulk gun. Cut nozzle at 45° angle to desired bead size marked on nozzle. Puncture inner seal with nail or wire.
Instant Grab Method for Paneling
Apply a 1/4" zig-zag bead of fast-bonding adhesive to each material that panel will be covering. Position panels so that edges meet at stud center. Press materials firmly into place, pull away for 1 to 3 minutes, then press back into place.
Instant Grab Method for Molding
Apply a 1/4" zig-zag bead of fast-bonding adhesive down center of molding strip. Press firmly into place, lift off for 1 to 3 minutes, then press back into place.
Working time up to 10 minutes. Dries in 24 hours. Fully cured in 7 days.
Use mineral spirits to clean up both wet and dry fast-bonding adhesive.