Interior Projects Adhesive (Low-VOC) (LN-704/LNP-704)

This high-strength, low-odor, latex construction adhesive features excellent flexibility, water resistance and long-term holding power when set. It's a versatile and convenient indoor construction adhesive that bridges gaps up to 3/8" and cleans up with water when wet. It's also considered a "green glue" because it is non-solvent and low-VOC.

 

LIQUID NAILS Interior Projects Construction Adhesive

BUY NOW



VIEW DEMO

Key Features

Recommended For:

foamboard, drywall, molding, paneling, plywood/hardboard, masonry/concrete, foamback tub surrounds, corkboard, ceramic tile repair, insulation board, and furring strips.

NOT Recommended For:

outdoor use or for application of mirrors, marble, ceiling tile, wood flooring, underwater use, or most tub surrounds (with the exception of foamback tub surrounds). Not recommended for bonding foamback tub surrounds directly to ceramic tile.

Available Sizes

  • 28 fl. oz. cartridge
  • 10 fl. oz. cartridge

Coverage

  • Using a 1/4" (.64 cm) bead: 28 fl. oz. cartridge covers 88 lineal ft.
  • Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 32 lineal ft.

Max VOC

35 GPL

Specifications

ASTM C 557

*Please note that the typical dry time for most construction adhesives is approximately 24 hours. This may vary due to temperature, humidity amount of product applied and surface porosity.
 

Get Adobe Reader to view certain LIQUID NAILS Adhesive product info

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

Surface Preparation

Make sure that all surfaces are clean, dry and structurally sound before construction adhesive is applied. Do not apply to moist concrete or masonry. Note: One surface must be porous.

Product Application

Cut and pre-fit materials prior to installation. Insert tube into caulk gun. Cut nozzle to desired bead size marked on nozzle. Puncture inner seal with nail or wire. Construction adhesive should be gunned at a room temperature of 60°F or higher. Adhere all materials before construction adhesive skins over.

Bonding Material To Furring Strips Or Studs

Apply a zig-zag 1/4" bead of construction adhesive to each strip or stud to be covered by material. Position materials so edges meet at stud center. Press firmly into place against wall. Finishing nails are required.

Bonding Foamboard, Foamback Tub Surrounds, Panels, Corkboard, etc. To Flat Surfaces

Apply 1/4" beads of construction adhesive in vertical zig-zag pattern over entire substrate surface. Construction adhesive beads should be a maximum of 12" apart and within 1-1/2" of all edges. Bracing may be necessary until adhesive has set.

Drying Time

Working time up to 30 minutes. Dries in 24 hours. Fully cured in 28 days.

Cleanup

If the construction adhesive is wet, use water. If the construction adhesive has dried, use mineral spirits.

Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.

Price and item availability may vary.

 
 

Learn about benefits and applications of LIQUID NAILS Interior Projects Construction Adhesive.

View Video View Video
 
 
;