installing crown molding, corkboard, paneling, wood molding, foil and insulation board.
NOT Recommended For:
uses other than paneling and molding installations, use between two non-porous surfaces, or exterior use.
Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 30 lineal ft.
You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.
All panels must be separated and conditioned to room temperature for 48 hours prior to installation. Preparation: Surfaces must be clean, dry and structurally sound before applying fast-bonding adhesive. Cut and pre-fit materials prior to installation.
Place cartridge in gun, cut nozzle and puncture inner seal with nail or wire. Apply 1/4" bead of fast-bonding adhesive around the perimeter of parts to be bonded. Adhere materials within 20 minutes of gunning this fast-bonding adhesive. Warped materials may require bracing and/or nailing. Instant-grab method: Paneling — Apply 1/4" bead of fast-bonding adhesive approximately 1" from edge of panel around the perimeter. Apply two zig-zag 1/4" beads in the middle of the panel. Press panel firmly into place. Remove panel from wall for one minute. Rejoin panel to wall. Molding — Apply 1/4" zig-zag bead of fast-bonding adhesive to back of molding. Press molding firmly into place. Starting at one end, nail every 12".
If this fast-bonding adhesive is wet, use water promptly. If the fast-bonding adhesive has dried, scrape it away, then remove residue using a cloth dampened with mineral spirits.
Visit these online retailers for a selection of LIQUID NAILS construction adhesive products.
Price and item availability may vary.